Physics307L:People/Gooden/Notebook/070827

set up

-I set up the oscilloscope with a BNC cable to ch1 connecting to the low output of the generator. Generator producing sine waves at ~50 Hz. Set on DC coupling. -ch1 positioned at v=0. Trigger set at v=0, slope-rising.

Measurements

Measurement- Voltage with original wave

    1. using the grid to measure amplitude  
       of the wave I get ~4.4 volts.
    2. using the cursor mode I find an      
       amplitude of ~4.64 volts.
    3. Using the measure control I again   
       find an amplitude of ~4.64 volts. 

    REPEATS:making voltage measurements using the measure 
    and cursor controls for waves of different 
    applitudes and 20 and 30 hz.
    1. 20hz wave, I find 2.72 volts after   
       adjusting the amplitude.
    2. 30 hz with another adjusted amplitude I find
       1.36 volts as the amplitude.

Measurements - frequency - original wave (f=1/T)

    1. Grid- I find period of ~20ms and so for frequency I find ~50hz
    2. Cursor- I find a frequency of ~50Hz
    3. Measure control- I find a frequency of ~49.50 Hz

    REPEATS:making frequency measurements using the measure 
    and cursor controls for waves of 2.4v 
    applitudes and 30 hz.

    1. Cursor- 30.6 Hz
    2. Measure control- I find 30.6 Hz

       * Trying these functions for different types of waveforms
        (square wave, etc) to measure frequency and amplitude
        the oscilloscope seems to do so properly.*