AU Biomaterials Design Lab:Protocols/Fluorescence Peltier System: Difference between revisions
From OpenWetWare
Jump to navigationJump to search
(New page: stuff) |
No edit summary |
||
Line 1: | Line 1: | ||
==Description== | |||
==Protocol== | |||
# Starting the Peltier controller | |||
## Make sure that the ribbon cord connects the peltier controller and the cuvette holder | |||
## Fill the chiller bucket with water | |||
## Place the aquarium pump (with tubes attached to the Peltier heat exchanger) into the bucket and plug in the pump so that water flows | |||
## Turn on the peltier controller (switch in the back of the instrument) | |||
## Use the arrow buttons to set the temperature. | |||
# Turning off the Peltier controller | |||
## Turn the controller power off | |||
## Unplug the aquarium pump | |||
## Dump the water from the bucket into the sink | |||
==Notes== | |||
==References== | |||
[[Category:Protocol]] | |||
[[Category:AU-BDL]] |
Latest revision as of 10:59, 26 August 2016
Description
Protocol
- Starting the Peltier controller
- Make sure that the ribbon cord connects the peltier controller and the cuvette holder
- Fill the chiller bucket with water
- Place the aquarium pump (with tubes attached to the Peltier heat exchanger) into the bucket and plug in the pump so that water flows
- Turn on the peltier controller (switch in the back of the instrument)
- Use the arrow buttons to set the temperature.
- Turning off the Peltier controller
- Turn the controller power off
- Unplug the aquarium pump
- Dump the water from the bucket into the sink