BME100 f2013:W1200 Group1 L4
BME 100 Fall 2013 | Home People Lab Write-Up 1 | Lab Write-Up 2 | Lab Write-Up 3 Lab Write-Up 4 | Lab Write-Up 5 | Lab Write-Up 6 Course Logistics For Instructors Photos Wiki Editing Help | ||||||||||||
OUR TEAMLAB 1 WRITE-UPInitial Machine TestingThe Original Design
The image shown above is of a device called an OpenPCR machine. An OpenPCR machine is a low cost, yet highly accurate thermocycler capable of performing polyermase chain reactions that amplifies a specific target DNA segment while maintaining extreme differences in temperature change. After going through many cycles of heating and cooling, the OpenPCR machine replicates a single strand of DNA into many copies. As seen in the image, the OpenPCR machine is connected to a computer using a USB cable. The computer uses an OpenPCR program that allows the number of cycles and each step and desired temperature and time to be adjusted accordingly. Thus, the OpenPCR machine begins the process according to the information inserted into the program. The image shown above is of the inside of the OpenPCR machine. The environmental changes of heating and cooling are controlled by the heater, heating lid, and cooling fan. The data collected is computed and transferred from the circuit board to the LED screen on top of the OpenPCR machine.
The PCR machine is heavily dependent on numerous connections and and interconnected parts. This means that, in order for it to work well, everything must be in its proper location and plugged in. This being said, when we unplugged part 3 (the LCD screen) from part 6 (circuit board) of the machine, the connection from the LCD to the circuit board was severed, resulting in the screen turning off. Also, when we unplugged the white wire that connects part 6 (circuit board) to part 2 (core) of the machine, the temperature changed from 26.7 degrees Celsius to -40 degrees Celsius. It is very important that all connections are correct in order to have an effective PCR machine. Test Run
ProtocolsThermal Cycler Program Initial Step 95°C for 3 minutes: The initial Template DNA strand separates Denature 95°C for 30 seconds: The DNA double helix separates, creating two single-stranded DNA molecules Anneal 57°C for 30 seconds: The two primers attach to opposite ends of the top and bottom strand of the target DNA segment Extend 72°C for 30 seconds: The DNA polymerase activates. Replication of the target DNA segment begins. Final Step 72°C for 3 minutes: The complementary binding of nucleotides continues until it gets o the end of the DNA strand and falls off. Final Hold 4°C: The PCR reaction ends.
The PCR reaction mix will contain 8 tubes. Each tube will contain 50μL of the following:
The DNA primer mix contains 50μL of the following:
Research and DevelopmentPCR - The Underlying Technology (Add a write-up, essay-style, organized into paragrpahs with descriptive headers, based on the Q&A's from Section three of your worksheet)
|