DNA Synthesis from Oligos
|back to protocols|
Despite claims by Synthesis companies for cheap gene/DNA synthesis, there are times when manual synthesis is necessary. This can be done relatively easily by ordering the necessary oligos of both strands, and a bit of thermo-cycling.
This synthesis can be accomplished using two methods: Ligation Chain Reaction (LCR) or Polymerase Chain Reaction (PCR). While both protocols are similar, they have some distinct differences which will be described here.
LCR Synthesis Procedure
- Design oligos for your gene, of both strands.
- Dilute the oligos to 100uM.
- Kinase the oligos.
- Ligation cycle:
- For Thermostable Taq ligase, cycle between:
- 95C (denature),
- 45-55C (anneal),
- 65C (ligate). Do many as necessary (10-30).
- For T4 ligase, cycle between(Do about 5-10 cycles, add bit more ligase, and ATP, do 5-10 more cycles):
- 95C (denature, 15 sec),
- 45-55C (anneal, 30 sec),
- 20C (ligate).
- Clean up.
- Rescue PCR with end primers, using ligation cycling product as template.
- Gel extract.
- T-vector or TOPO clone.
PCR Synthesis Procedure
- Primer design for the two types of synthesis are different. For a rough determination of primers see the figure to the right. Arrows point in the 5' to 3' direction.
- Make primers fixed 30-40mers with 15-20mer overlaps; or use the software by Rouillard et al. referenced below.
- This works well for relatively for short fragments (300-500 bp). For longer sequences, use PCR Overlap Extension of the fragments.
Rouillard et al. Gene2Olig: oligonucleotide design for in vitro gene syntehsis.