DNA extraction - Salting Out

From OpenWetWare
Revision as of 23:11, 22 April 2008 by Marcus McHale (talk | contribs)
Jump to navigationJump to search

Curators

  • This protocol has evolved with me and I am sure many others, please share your optimisations.

Anyone should feel free to add themselves as a curator for this consensus protocol. You do not need to be a curator in order to contribute. The OpenWetWare community is currently discussing the idea of protocol curators. Please contribute.

Abstract

  • Simple procedure for DNA extraction and purification from tissue using salt

Materials

  1. Pipettes and tips
  2. 1.5ml microcentrifuge tubes

Reagents

  1. Digestion Buffer (pH 8.0): 10mM NaCl, 10mM TRIS (pH 8.0), 10mM EDTA (pH 8.0), 0.5% SDS,
  2. Proteinase K 20mg/mL
  3. Sodium Acetate 3M (pH 5.2)
  4. Ethanol 70% and 98% (chill prior to use)

Equipment

  1. Incubator/Water Bath: preferably shaking
  2. Centrifuge: preferably refrigerated

Procedure

  1. Add 5μL Proteinase K to each mL of Digestion Buffer
  2. Homogenise (or simply place) tissue in solution
  3. Incubate at 55°C for 1 hour to overnight
  4. Centrifuge at maximum speed in a benchtop centrifuge for 2 minutes
  5. Transfer supernatant into a new tube
  6. Add 1/10 volume of Sodium Acetate 3M (pH5.2)
  7. Invert to mix and incubate at -20°C for ~30 minutes
  8. Centrifuge (preferably at 4°C) at maximum speed in a benchtop centrifuge for 20 minutes
  9. Transfer supernatant to a new tube
  10. Add >2 volumes of 98% ethanol
  11. Invert to mix and incubate at -20°C for 30 minutes
  12. Centrifuge (preferably at 4°C) at maximum speed in a benchtop centrifuge for 20 minutes
  13. Wash pellet with 70% ethanol, dry and resuspend in water or TE

Critical steps

  • After adding sodium acetate and centrifuging be careful not to transfer any of the white solid (SDS) into the fresh tube
  • Ensure to dry the pelletted DNA completely before attempting to resuspend

Troubleshooting

Notes

  • You may wish to kill the Proteinase K (95°C, 10 minutes) after the extraction though if you are proceding straight to PCR (and don't leave your reactions sitting around before thermal cycling) the denaturation step will take care of that
  • Successfully used on fish, mammal and insect tissue.
  • Works well in 96 well plate format, to remove ethanol following precipitation/wash simply invert the plate over a sink then spin gently (~100 rcf) inverted over absorbant paper.

Acknowledgments

  • Damien Broderick from Queensland Depaqrtment of Primary Industries and Fisheries supplied me with his version of this protocol to start me off.

References

  • Miller SA, Dykes DD, Polesky HF (1988) A simple salting out procedure for extracting DNA from human nucleated cells. Nucleic Acids Research, 16, 1215–1215.

Specific Protocols

Discussion

You can discuss this protocol.