Design a Microfluidic Chip
From OpenWetWare
(Difference between revisions)
| Line 1: | Line 1: | ||
| - | [ | + | The process of designing a microfluidic chip to be ordered from the [http://thebigone.caltech.edu/foundry/ Caltech Foundry ] is not hard but it is a little involved. |
| - | + | ==Steps== | |
| + | |||
| + | #Learn the design rules | ||
| + | #Make a rough outline of your chip design | ||
| + | #*This should be influenced by previous designs as well as constraints of the design rules | ||
| + | #gain a (rudimentary) understanding of AutoCAD | ||
| + | #Create a schematic of your chip in autoCAD | ||
[[Design Rules for Microfluidics]] | [[Design Rules for Microfluidics]] | ||
| + | |||
| + | |||
| + | [[Category:Microfluidic Protocol]] | ||
Revision as of 18:20, 3 May 2005
The process of designing a microfluidic chip to be ordered from the Caltech Foundry is not hard but it is a little involved.
Steps
- Learn the design rules
- Make a rough outline of your chip design
- This should be influenced by previous designs as well as constraints of the design rules
- gain a (rudimentary) understanding of AutoCAD
- Create a schematic of your chip in autoCAD
