Drosophila CHiP on chip
If you are interested in doing CHiP chip with Drosophila then please feel free to contribute to the protocols found here. The original protocol was added and adapted with permission from Rob White's lab. You can download the original from www.FlyChip.org.uk
Important: This protocol is dynamic, feel free to discuss any stages and make changes as you see fit. If you use are currently using this protocol in the lab then it is important that you make a note of the date of the version that you are using and return to this if you need to repeat the experiment. You can find the history by clicking on the history tab above. The history never changes, allowing you reference a particular protocol at a snap shot in time.
- Incubate embryos at 37 °C for 15 minutes to heat shock the embryos (omit this step if non−heat
shocked embryos are required).
- Dechorionate embryos for 3 minutes in a solution of weak bleach (5% w/w available chlorine) at
- Wash well with tap water and place onto filter paper. Transfer to fresh filter paper to weigh.
Transfer 1−2 g of embryos to a 50 ml Falcon tube and add 50 ml PBS/Triton to wash the embryos. Centrifuge for 1 minute at 500 x g (1680 rpm) to pellet embryos.
- Discard supernatant and add 10 ml cross−linking solution, 487 μl 40% formaldehyde and 30 ml
n−heptane. Shake vigorously (by hand works well...but tiring) at room temperature for 15 minutes.
- Centrifuge for 1 minute at 500 x g (1680 rpm) to pellet embryos and discard supernatant.
Resuspend in 30 ml PBS/Glycine/Triton, best to resuspend in 3 ml of buffer and then add the rest. Then allow the embryos to sediment.
- Remove supernatant and add 50 ml ice−cold PBS/Triton and resuspend. Best to add a small volume
of the buffer to resuspend the embryos. Allow the embryos to sediment.
- Remove supernatant and resuspend in 15 ml ice−cold PBS/Triton + protease inhibitors, again
resuspend in a small volume and then add remainder. Dounce with a Wheaton homogeniser pestle B.
- Centrifuge at 400 x g (1500 rpm) for 1 minute and transfer supernatant to a fresh tube.
Centrifuge at 1100 x g (2495 rpm) for 10 minutes at 4 °C and discard supernatant. Resuspend in 15 ml ice−cold Cell Lysis Buffer with protease inhibitors, best to resuspend in a small volume and then add remainder. Dounce with a Wheaton homogeniser pestle A. Transfer 2 equal aliquots into 13.5 ml screw−capped conical base tubes.
- Centrifuge at 2000 x g (3365 rpm) for 4 minutes at 4 °C to pellet the nuclei.
Resuspend in 1 ml of ice−cold Nuclear Lysis Buffer with protease inhibitors, incubate for 20 minutes at 4 °C.
- Add 2 ml ice−cold Nuclear Lysis Buffer with protease inhibitors and 0.3 g acid washed 212−300
micron glass beads.
- Sonicate on ice following the regime below to produce chromatin fragments with an average size of
500 bp using a sonicator fitted with a microtip. This step should be calibrated for individual 15.
- The protocol is not complete, I'm currently moving it from the PDF to the web, I'll be adding details for collection of chromatin from whole flies rather than from embryos (the original protocol).
- please add Q & A here
Recent changes/changes from original flychip.org
- please add any changes here
- --Johncumbers 10:31, 18 April 2006 (EDT)