Endy:Measuring PoPS on a plate reader
From OpenWetWareAdd to My Links
Back to plate reader.
This is a naive attempt to infer PoPS from plate reader measurements of fluorescence. This analysis depends on many assumptions, only a small number of which are explicitly stated at the moment. The document and model are at a draft stage so please correct typos, math/unit errors.
Measuring protein numbers
See Standardized GFP quantification for a methodology to relate relative fluorescence measurements from the plate reader back to copies of a fluorescent reporter per well. Previous work, here and here has shown that absorbance measurements on the plate reader can be related to colony forming units (cfu). Assuming these calibrations have been done, we can use the protein copy measurements as an input to a simple model relating protein production rate to PoPS/cell.
Protein production model
Without derivation, here is a simple, widely used model of protein production within a single cell. The model consists of two differential equations, one governing the rate of accumulation of reporter mRNA per cell and the other governing reporter protein accumulation per cell.
= Reporter mRNA concentration per cell, [mRNA]
= Reporter protein concentration per cell, [Protein]
= Reporter DNA molecule concentration per cell, [DNA]
= mRNA production rate (PoPS), [mRNA]/[DNA]/s
= Protein production rate (RiPS), [Protein]/[mRNA]/s
γM = mRNA degradation rate, 1/s
γP = Protein degradation rate. Note that for a stable protein, this becomes equal to dilution rate due to growth, 1/s
Anyone want to fix the gammas?
Since mRNA degradation rates are fast (~1min) and since mRNA production rates are also fast, we can assume that reporter mRNA levels are in pseudo steady state. Hence we can solve Eqn. 1 to yield -
We can rewrite Eqn. 1 in terms of to yield -
(3) and (4) can be combined to yield a relation between PoPS and protein levels and rates of production.
Using the model
Jennifer Braff and Caitlin Conboy have measured mRNA degradation rates for GFP. In addition, they have measured RiPS for GFP from BBa_B0032 among other RBSs. As mentioned above we can approximate the protein degradation rate by the dilution rate due to growth. Given these parameters, the model can be used to crudely estimate PoPS from protein copy measurements on the plate reader. For this to be in any way accurate, the same parts and conditions should be used as were used by Jen and Caitlin.