Godin:Protocols/Multilayer PDMS

Home        Calendar        Contact        Lab Members        Protocols        Publications        Research        Orders       

Safety Safety goggles Nitrile gloves Lab coat Clean room gowning Fume hood Materials Valve and Microchannel masters Distilled water Ethanol Isopropanol Stereo microscope Scotch tape Pipette tip Tweezers Polystyrene dish Vacuum Oven Aluminum foil Weighing dish Scale PDMS Godin:Protocols/Sonicator Godin:Protocols/Spin coater Godin:Protocols/Mask aligner Description This protocol details the fabrication of a 2 layer PDMS device, consisting of a valve layer (top) and channel layer (below). It is assumed that masters for respective layers have already been fabricated (see Godin:Protocols/SU-8 Master, Godin:Protocols/AZ Master). The idea is to modify the silicone elastomer base to curing agent ratio, thereby modifying PDMS elasticity. Valve Layer Mix PDMS 7:1 For most devices, 80g of PDMS is sufficient to produce reasonably-sized devices. Weigh 70g of silicone elastomer base on the scale using the weighing dish, then add 10g of curing agent. Make sure to maintain the 7:1 ratio; if too much is added, add more base as required. Use a pipette tip to mix the solution for 10 min under the fume hood. Blow dry the valve master with nitrogen, and place in a polystyrene dish. Use Scotch tape to fix the wafer at the center of the dish by taping all sides. We want to prevent the wafer from floating up, or PDMS from getting under the wafer. Close the dish with the lid. 30 min degass Place 12 min @ 80°C Punch valve holes Cleaning Fluidic Layer Mix PDMS 20:1 30 min degass Spin coat 10 min @ 80°C Device Fabrication Alignment >2 hrs @ 80°C Punch fluidic holes Cleaning