IGEM:Melbourne/2008/BCRiboswitch

From OpenWetWare

< IGEM:Melbourne | 2008(Difference between revisions)
Jump to: navigation, search
Current revision (00:31, 31 March 2008) (view source)
 
(3 intermediate revisions not shown.)
Line 1: Line 1:
[[IGEM:Melbourne/2008|Return to Melbourne Homepage]]
[[IGEM:Melbourne/2008|Return to Melbourne Homepage]]
 +
 +
'''Riboswitch''' is a component we will use to allow parts in the Bioclock system to cycle between 3 states: (i) ‘off’ state, (ii) ‘ready to go’ state (iii) ‘on’ state. The 1st input signal into the system will cause the part to go from (i) to (ii); the subsequent signal will cause it to go from (ii) to (iii). The part will then eventually go back to (i). For details, check out the links below.
Line 9: Line 11:
*'''[[/Online programs|Online programs]] for designing riboswitches'''
*'''[[/Online programs|Online programs]] for designing riboswitches'''
-
*'''[[/Riboswitches from Bioparts Registry|Ribswitches from Bioparts Registry]]'''
+
*'''[[/Existing Riboswitches|Existing Riboswitches]]'''
*'''[[/References|References]]'''
*'''[[/References|References]]'''
*'''[[/Further Reading|Further Reading]]'''
*'''[[/Further Reading|Further Reading]]'''

Current revision

Return to Melbourne Homepage


Riboswitch is a component we will use to allow parts in the Bioclock system to cycle between 3 states: (i) ‘off’ state, (ii) ‘ready to go’ state (iii) ‘on’ state. The 1st input signal into the system will cause the part to go from (i) to (ii); the subsequent signal will cause it to go from (ii) to (iii). The part will then eventually go back to (i). For details, check out the links below.


Personal tools