IGEM:Melbourne/2008/BCRiboswitch
From OpenWetWare
< IGEM:Melbourne | 2008(Difference between revisions)
Current revision (01:31, 31 March 2008) (view source) |
|||
| (2 intermediate revisions not shown.) | |||
| Line 1: | Line 1: | ||
[[IGEM:Melbourne/2008|Return to Melbourne Homepage]] | [[IGEM:Melbourne/2008|Return to Melbourne Homepage]] | ||
| + | |||
| + | '''Riboswitch''' is a component we will use to allow parts in the Bioclock system to cycle between 3 states: (i) ‘off’ state, (ii) ‘ready to go’ state (iii) ‘on’ state. The 1st input signal into the system will cause the part to go from (i) to (ii); the subsequent signal will cause it to go from (ii) to (iii). The part will then eventually go back to (i). For details, check out the links below. | ||
| Line 9: | Line 11: | ||
*'''[[/Online programs|Online programs]] for designing riboswitches''' | *'''[[/Online programs|Online programs]] for designing riboswitches''' | ||
| - | *'''[[/Riboswitches | + | *'''[[/Existing Riboswitches|Existing Riboswitches]]''' |
*'''[[/References|References]]''' | *'''[[/References|References]]''' | ||
*'''[[/Further Reading|Further Reading]]''' | *'''[[/Further Reading|Further Reading]]''' | ||
Current revision
Riboswitch is a component we will use to allow parts in the Bioclock system to cycle between 3 states: (i) ‘off’ state, (ii) ‘ready to go’ state (iii) ‘on’ state. The 1st input signal into the system will cause the part to go from (i) to (ii); the subsequent signal will cause it to go from (ii) to (iii). The part will then eventually go back to (i). For details, check out the links below.
- Online programs for designing riboswitches
