Knight:Annealing and primer extension with Taq polymerase

From OpenWetWare

Revision as of 14:50, 26 May 2006 by Reshma P. Shetty (Talk | contribs)
(diff) ←Older revision | Current revision (diff) | Newer revision→ (diff)
Jump to: navigation, search

This protocol uses annealing and primer extension to generate a short fragment of DNA (~100 bp) using Taq polymerase. The DNA fragment can be immediately used in a TA cloning reaction. (To proceed to a restriction digest step, purification is necessary.)



  • Two oligos which overlap by ~20 bp. See notes for more information on primer ordering. See notes for more information on efficient addition of 3'A to PCR products.

Oligo 1:    5' ----------------------------------- 3'
Oligo 2:                                        3' ----------------------------------- 5'


  1. Dilute the two oligos to a concentration of 25 μM using H2O
  2. Mix the following in a 0.6 mL sterile tube
    • 9 μL PCR supermix
    • 0.5 μL oligo 1
    • 0.5 μL oligo 2
  3. Anneal and extend the two oligos together by placing the mixture in a thermal cycler (MJ Research, PTC-200) and running the following protocol.
    1. 94°C for 5 mins
    2. 94°C for 30 seconds
    3. 56°C for 30 seconds (or whatever an appropriate annealing temperature is)
    4. 68°C for 30 seconds
    5. Repeat steps 2-4 2-3 cycles
    6. 68°C for 5 mins
  4. Use fresh 1μL PCR product in a TOPO TA cloning reaction.


  • For oligos greater than 50-60 bp in length, there can often be problems with errors or deletions in the primers. Therefore, it might be worth ordering your primers with an extra purification step such as PAGE. Invitrogen custom primers offers this service for an extra fee.


Error fetching PMID 7590320:
  1. Error fetching PMID 7590320: [Stemmer-Gene-1995]
Personal tools