Knight:Reconstituting primers

From OpenWetWare

(Difference between revisions)
Jump to: navigation, search
(Notes)
Line 17: Line 17:
See [[Reconstituting primers]] for a lot of useful information including why you should use TE buffer rather than water for reconstituting primers.
See [[Reconstituting primers]] for a lot of useful information including why you should use TE buffer rather than water for reconstituting primers.
-
[[Category:Protocol]] [[Category:DNA]]
+
[[Category:Protocol]] [[Category:DNA]] [[Category:In vitro]]

Revision as of 11:34, 14 March 2007

Contents

Procedure

Invitrogen recommends the following reconstitution procedure -

  1. Centrifuge the tube for a few seconds to get all the DNA to the bottom of the tube.
  2. To make a 25 μM stock, add YμL of sterile H2O to X nmoles of dry primer stock. (See equations below).
  3. Allow to sit for 2 mins, then vortex for 15 secs.

Short version

Y\ \mu L\ =\ 40\ *\ X\ nmoles\ primer

The number of nmoles of material in the tube (X) should be listed on the pages accompanying your primer order.

Long version

Y\ \mu L\ =\ \frac{1}{25\ \mu L}*X\ nmoles\ primer\ =\ \frac{1*10^6\ \mu M}{25000\ nmoles}*X\ nmoles\ primer\ =\ 40\ *\ X\ nmoles\ primer

Notes

See Reconstituting primers for a lot of useful information including why you should use TE buffer rather than water for reconstituting primers.

Personal tools