Lidstrom: SDS-PAGE: Difference between revisions
From OpenWetWare
Jump to navigationJump to search
Line 71: | Line 71: | ||
== Acrylamide toxicity == | == Acrylamide toxicity == | ||
*[http://en.wikipedia.org/wiki/Acrylamide Acrylamide] is [http://oehha.ca.gov/prop65/acrylamideqa.html toxic] to your nervous system, and may be a carcinogen. The unpolymerized form is toxic, but the polymerized form is much less toxic. ALWAYS wear gloves and wipe up spills - once the solution drys, the dust can be [http://www.nap.edu/openbook.php?record_id=4911&page=250 inhaled]. Interestingly, fried starchy/sugary foods naturally contain acrylamide, too. | *[http://en.wikipedia.org/wiki/Acrylamide Acrylamide] is [http://oehha.ca.gov/prop65/acrylamideqa.html toxic] to your nervous system, and may be a carcinogen. The unpolymerized form is toxic, but the polymerized form is much less toxic. ALWAYS wear gloves and wipe up spills - once the solution drys, the dust can be [http://www.nap.edu/openbook.php?record_id=4911&page=250 inhaled]. Interestingly, fried starchy/sugary foods naturally contain acrylamide, too. | ||
*more than you want to know about acrylamide toxicity can be found [http://jifsan.umd.edu/docs/acrylamide2002/wg4_toxicology_bg.pdf here] |
Revision as of 07:17, 14 September 2012
Return: Protocols
Gel Prep
- Clean cover plate and thicker spacer plate 75 mM
- Soap and Water
- Ethanol
- DI water
- Dry plates
- Setup one spacer plate and one cover plate in each gel holder
- The cover plate goes on the side of the spacer plate with the spacers in order to create a small gap between the plates
- Put the gel holder into the casting stand
Pour the Resolving Gel
- Mix components of the amounts in the Gel Mix link for the resolving gel (Recipes is for 4 gels). Mix in the order listed.
- Gel Mix Recipe
- Don't add APS/TEMED until ready to pour
- Use pipette to put gel mix into the gap between the plates
- Carefully layer 50%EtOH 50% ddH2O on top of the gel to prevent the top of the gel from drying out
- Let dry for an hour
- Store at 4 deg C wrapped in a wet paper towel and saran wrap if you're not going to use it right away.
Pour the Stacking Gel
- Replace gel in gel holder
- Dry surface of gel carefully with Kimwipe or paper towel
- It can be a little gooey
- Mix components of the amounts in the Gel Mix link. Mix in the order listed.
- Gel Mix Recipe
- Don't add APS/TEMED until ready to pour
- Use pipette to put gel mix into the gap between the plates
- Insert the comb being 'careful not to trap any bubbles'
- Attach binder clips to help hold the comb in while drying. One in either side of the casting stand clamp.
- Let dry for an hour
Sample Prep
- 10-20 ug protein
- Load 12-15 uL, absolute max 20 uL for big comb
- Denature protein
- Mix with sample buffer & BME
- Boil for 5-10 min (can do longer times at lower temp, too.)
Running the Gel
- Bio-Rad Mini-Cell Setup
- If only 1 gel, use buffer dam to replace second gel
- Slot gels with cover plates facing each other...
- Apply pressure on gel holder and gels as you close the tabs to seal the center compartment.
- Fill central compartment with running buffer
- Pour rest into outer compartment
- Load gel
- Make sure to color/charge-match the cords to the power unit as the electrodes in the gel holder to the contacts in the lid.
- Run 30-45 min @250V
Staining, Destaining, & Visualization
- dye overnight or cycles of 1 min @ power 6 in the microwave
- Return dye to container
- Rinse to remove residual dye
- Destain (I do 2 rounds at least)
Other Resources
Mistakes to Be Careful About
- letting the gel dry too long after pouring the stacking gel (comb step)
- the very edges can shrivel up, which becomes a problem when you try to use those edge lanes
- sample sloshing out of the well you are using into a neighboring well
Acrylamide toxicity
- Acrylamide is toxic to your nervous system, and may be a carcinogen. The unpolymerized form is toxic, but the polymerized form is much less toxic. ALWAYS wear gloves and wipe up spills - once the solution drys, the dust can be inhaled. Interestingly, fried starchy/sugary foods naturally contain acrylamide, too.
- more than you want to know about acrylamide toxicity can be found here