Lidstrom Lab French Press: Difference between revisions
From OpenWetWare
Jump to navigationJump to search
(New page: ===French Press===) |
|||
Line 1: | Line 1: | ||
===French Press=== | ===French Press=== | ||
Collect your equipment: | |||
* 1- Cell cylinder | |||
* 2- Screw valve | |||
* 3- Piston | |||
* 4- Cylinder cap | |||
* 5- Spigot | |||
[[Image:FPparts.jpg|200px]] | |||
Prepare the equipment: | |||
* Check the condition of the O-rings on the piston and cylinder bottom before starting your extraction | |||
::- If they are shredded, sticky or warped you should change them | |||
::- There are 2 types of O-ring, flat and rounded; the rounded O-ring should be positioned on the outside | |||
* Check the condition of the nylon ball housed in the screw valve | |||
::- The ball must be rounded to effectively adjust pressure | |||
::- Flattened or squared off balls should be changed out | |||
::- Use a razor blade to pry the malformed ball out of the housing and place a new ball in the opening | |||
* Refridgerate setup at 4°C until thoroughly cold | |||
'''You must have someone show you how to operate the press itself if you have never used it,''' but here is an overview of the press controls: | |||
* 1- Pressure gauge | |||
* 2- Pressure dial (increase/decrease psi) | |||
* 3- Ratio selector (up/down) |
Revision as of 14:13, 3 June 2013
French Press
Collect your equipment:
- 1- Cell cylinder
- 2- Screw valve
- 3- Piston
- 4- Cylinder cap
- 5- Spigot
Prepare the equipment:
- Check the condition of the O-rings on the piston and cylinder bottom before starting your extraction
- - If they are shredded, sticky or warped you should change them
- - There are 2 types of O-ring, flat and rounded; the rounded O-ring should be positioned on the outside
- Check the condition of the nylon ball housed in the screw valve
- - The ball must be rounded to effectively adjust pressure
- - Flattened or squared off balls should be changed out
- - Use a razor blade to pry the malformed ball out of the housing and place a new ball in the opening
- Refridgerate setup at 4°C until thoroughly cold
You must have someone show you how to operate the press itself if you have never used it, but here is an overview of the press controls:
- 1- Pressure gauge
- 2- Pressure dial (increase/decrease psi)
- 3- Ratio selector (up/down)