Lidstrom Lab French Press: Difference between revisions
From OpenWetWare
Jump to navigationJump to search
No edit summary |
|||
Line 6: | Line 6: | ||
* 4- Cylinder cap | * 4- Cylinder cap | ||
* 5- Spigot | * 5- Spigot | ||
[[Image: | [[Image:numberedFP.jpg|600px]] | ||
Prepare the equipment: | Prepare the equipment: |
Revision as of 09:45, 14 June 2013
French Press
Collect your equipment:
- 1- Cell cylinder
- 2- Screw valve
- 3- Piston
- 4- Cylinder cap
- 5- Spigot
Prepare the equipment:
- Check the condition of the O-rings on the piston and cylinder bottom before starting your extraction
- - If they are shredded, sticky or warped you should change them
- - There are 2 types of O-ring, flat and rounded; the rounded O-ring should be positioned on the outside
- Check the condition of the nylon ball housed in the screw valve
- - The ball must be rounded to effectively adjust pressure
- - Flattened or squared off balls should be changed out
- - Use a razor blade to pry the malformed ball out of the housing and place a new ball in the opening
- Refridgerate setup at 4°C until thoroughly cold
You must have someone show you how to operate the press itself if you have never used it, but here is an overview of the press controls:
- 1- Pressure gauge
- 2- Pressure dial (increase/decrease psi)
- 3- Ratio selector (up/down)