Mathies:Drilling in BNC
From OpenWetWare
(Difference between revisions)
| Line 10: | Line 10: | ||
Make sure you have read the entire operation manual BEFORE asking for a training session with Erik Jensen. His email is erik_jensen [at] berkeley [dot] edu. You may have other options (easier ways) than using a CNC mill. | Make sure you have read the entire operation manual BEFORE asking for a training session with Erik Jensen. His email is erik_jensen [at] berkeley [dot] edu. You may have other options (easier ways) than using a CNC mill. | ||
| + | |||
| + | |||
| + | ==Preparation== | ||
| + | |||
| + | Please refer to Mathies:Drilling a Glass Microfluidic Wafer in the Microfabrication in Microlab section. | ||
| Line 15: | Line 20: | ||
Please refer to the manual. You can download it here. | Please refer to the manual. You can download it here. | ||
| + | |||
| + | |||
| + | |||
Revision as of 23:37, 29 July 2009
Contents |
Drilling in BNC
READ first
Make sure you have read the entire operation manual BEFORE asking for a training session with Erik Jensen. His email is erik_jensen [at] berkeley [dot] edu. You may have other options (easier ways) than using a CNC mill.
Preparation
Please refer to Mathies:Drilling a Glass Microfluidic Wafer in the Microfabrication in Microlab section.
Procedure
Please refer to the manual. You can download it here.
Contact
- Eric Chu 20:35, 29 July 2009 (PDT):
or instead, discuss this protocol.
