Mathies:Drilling in BNC: Difference between revisions
From OpenWetWare
Jump to navigationJump to search
(New page: Category:Protocol Category:Microfluidics <!-- COPY EVERYHING BELOW HERE TO START YOUR OWN PROTOCOL! --> ==Drilling in BNC== '''->READ first<-''' Make sure you have read the e...) |
(No difference)
|
Revision as of 20:35, 29 July 2009
Drilling in BNC
->READ first<-
Make sure you have read the entire operation manual BEFORE asking for a training session with Erik Jensen. His email is erik_jensen [at] berkeley [dot] edu. You may have other options (easier ways) than using a CNC mill.
Procedure
Please refer to the manual. You can download it here.
Contact
- Eric Chu 20:35, 29 July 2009 (PDT):
or instead, discuss this protocol.