Registry/Measurement kit/Instructions

From OpenWetWare

< Registry | Measurement kit
Revision as of 12:22, 14 January 2008 by Jason R. Kelly (Talk | contribs)
(diff) ←Older revision | Current revision (diff) | Newer revision→ (diff)
Jump to: navigation, search

Contents

Promoter Measurement Kit Instructions

The steps for using the Promoter Measurement Kit for testing a promoter.

Oligo design

We recommend building your promoter from oligo annealing. If you are testing a part or device larger than ~80bp you can use miniprep and digest in place of oligo annealing. Just be sure to gel purify the part from the plasmid it was on if that plasmid has KanR -- if it doesn't contain KanR a purification step should probably be skipped (due to the inefficiency of a typical gel isolation).

Oligos should be designed to attach a BioBrick prefix and suffix to your promoter, and to create an EcoR1 overhang on the 5' end and a SpeI overhand on the 3' end. You should order your oligos with a 5' phosphate or add one with PNK.

Example of typical promoter

Promoter sequence:

Desired final construct:

Both are given 5'->3': PromoterXFWD Primer: PromoterXREV Primer

Oligo annealing

Ligation

We have been playing around with the conditions here a bit, and the best so far is:

  • 3K3 (<10ng/uL) + I13401 (<10ng/uL) + I20258 (6.4ng/uL)
    • The I20258 was a 1/100 dilution from the product of oligo annealing.

Transformation

10 of 15 colonies yielded a PCR product of the correct length; The rightmost lane is the positive control
10 of 15 colonies yielded a PCR product of the correct length; The rightmost lane is the positive control
  • We recommend testing your part in TOP10 cells to best mimic the conditions of previously characterized promoters in the Registry.
  • The ligation conditions above yielded 140 colonies which was 10X greater than samples where 3K3 and I13401 were added in (1/10) concentrations. Based on length verification via colony PCR 66% of the colonies appear to have had the primer inserted properly. (see fig)

RBS Measurement Kit Instructions

Old Notes

Just posting notes here from going through the process of building the 16 test constructs. Since this is essentially the process that a user of the kit would be doing when they inserted their RBS or Promoter.

Example miniprep of measurement kit components

  • GFP Promoter Tester Version 1 E/S <BBpart> I20244</BBpart> - 27.2
  • GFP Promoter Tester Version 2 E/X <BBpart> I20245</BBpart> - 29.8
  • RFP Promoter Tester Version 1 E/S <BBpart> I20246</BBpart> - 23.2
  • RFP Promoter Tester Version 2 E/X <BBpart> I20247</BBpart> - 23.1
  • GFP RBS Tester Version 1 E/X <BBpart> I20248</BBpart> - 31.5
  • GFP RBS Tester Version 2 S/X <BBpart> I20249</BBpart> - N/A
  • RFP RBS Tester Version 1 E/X <BBpart> I20250</BBpart> - 25.4
  • RFP RBS Tester Version 2 S/X <BBpart> I20251</BBpart> - 30.2
Personal tools