User:Darrell Bonn/Notebook/307L Lab book/lab Millikan Summary

From OpenWetWare

(Difference between revisions)
Jump to: navigation, search
Line 16: Line 16:
-
I carried out all calculations in Mathcad as I expected to be able to save that to a file that could be directly uploaded as part of this page. It turns out that MHT files are prohibeted on wiki, so I have placed it in a word document instead. The calculations and summary are located there which can be opened by following this link: [http://openwetware.org/wiki/Image:Millikan.docx Millikan Summary]
+
During the lab, it was noticed that there were a high number of anomalous data. We decided that unless we could get three readings for both falling and rising times on a single drop, then we could not accept it as having value. Therefore, in the analysis, only those drops which had 3 or more readings for both rise and fall time were used for calculations. It would have been better to have decided this prior to beginning the lab, but it was experience with the lab which suggested this criterion for acceptable data. Althouh the criterion was established during data acquisition, it should be noted that it was established well before data analysis began and we therefore believe it to be an unbiased decision. We recommend that anyone else performing this lab set that criterion forward prior to begining.
 +
 
 +
 
 +
All calculations were carried out in Mathcad as I expected to be able to save that to a file that could be directly uploaded as part of this page. It turns out that MHT files are prohibeted on wiki, so I have placed it in a word document instead. The calculations and summary are located there and can be opened by following this link: [http://openwetware.org/wiki/Image:Millikan.docx Millikan Summary]

Revision as of 16:54, 14 December 2008

Contents

Millikan Lab Summary

Lab Partner: Boleszek
Essential lab procedures were takne from the manual for the PASCO scientific Model AP-8210 "Millikan Oil Drop Apparatus" which can be found online here: 8210 Manual.pdf

Purpose

To reproduce a measurement of the charge of an electron


Procedure

The procedure is fairly well shown in our lab notes and in the 8210 manual bookmarked above. It takes a bit of time to get used to the device, but it is not too difficult to acquire decent data as is shown by our results.


Calculations

Methods for calculating the charge are well documented in the apparatus manual pages 2 and 9. These techniques were used without modification.


During the lab, it was noticed that there were a high number of anomalous data. We decided that unless we could get three readings for both falling and rising times on a single drop, then we could not accept it as having value. Therefore, in the analysis, only those drops which had 3 or more readings for both rise and fall time were used for calculations. It would have been better to have decided this prior to beginning the lab, but it was experience with the lab which suggested this criterion for acceptable data. Althouh the criterion was established during data acquisition, it should be noted that it was established well before data analysis began and we therefore believe it to be an unbiased decision. We recommend that anyone else performing this lab set that criterion forward prior to begining.


All calculations were carried out in Mathcad as I expected to be able to save that to a file that could be directly uploaded as part of this page. It turns out that MHT files are prohibeted on wiki, so I have placed it in a word document instead. The calculations and summary are located there and can be opened by following this link: Millikan Summary


As a final note, viscosity of air was calculated with the help of an online viscosity calculator

Comments

Personal tools