- to run transformations of PCR product into E. coli cells
- to run FPLC on the ADA protein from the third and the fourth of November.
- The cells from the fourth of November were sonciated for 30 seconds and then placed in an ice bath for 30 seconds. This was repeated for a total of 3 times.
- The cells were then transferred to centrifuge tubes, balanced, and placed in the centrifuge at 18,000rpm at 4°C for 2 hours.
- The cells were then filtered using...
- The cells were then run on FPLC, using the binding buffer and elusion buffer from September 26th.
- The cells were collected in 5 mL aliquots and transferred into a Falcon tube.
- The Au/Lysozyme solutions were obtained from the oven. The following images are the results from the Au/Lysozyme reaction.
- The range of Au/Lysozyme ratios, between 20uM ratio to 130 uM ratio.
- A close up of Au/Lysozyme ratios, focusing on the difference between the homologous solutions and the protein fiber solutions.
- For the transforamtion of PCR product into E. coli cells, 20μL of PCR DNA and 30μL of E. coli cells were added to a centrifuge tube, in a sterile environment, and then placed in an ice bucket. (This occurred twice, one for each PCR tube.)
- The cells were heat schoked by incubating them in a 42°C water bath for 30 seconds and then placed immediately on ice.
- 250μL of room temperature SOC medium was added to one of the PCR tubes and 250μL of Albumin medium was added to the other PCR tube.
- The cells were shaken at 225 rpm of an hour at 37°C.