User:Keyun Wang/Notebook/Experimental Biological Chemistry I/2013/04/07

From OpenWetWare

< User:Keyun Wang | Notebook | Experimental Biological Chemistry I | 2013 | 04
Revision as of 23:50, 7 April 2013 by Keyun Wang (Talk | contribs)
(diff) ←Older revision | Current revision (diff) | Newer revision→ (diff)
Jump to: navigation, search
15 Hour Cell Growth Experiment - testing the effect of AgLMT/polymer FIlm Main project page
Previous entry      Next entry


  • Run 15 hour cell growth experiment with silver incorporated clay/polymer film and clay/polymer film made on 2013/04/03


  • Starter culture was thawed in room temperature.
  • 3mL of sterile LB media was pipetted into falcon tube to resuspend pellet
  • 1mL of resuspended culture was pipetted into each 50mL sterilized LB.
  • Above two processes were repeated for six more times to make a total of 7 cell cultures in 7 flasks.
  • First flask including LB and cell serve as control.
  • One of each LMT+AG200D film was placed in three other flasks, respectively.
  • One of each AG-incorporated LMT+AG200D film was placed in the last three flasks, respectively.
  • All flasks were placed in incubator shaker for 15 hours, 230rpm, at 37°C.
  • Absorbance of 3mL cell culture was taken every three hours using UV-vis spectrometer at 600.0nm.
  • The absorbance of all cell culture was measured against water.
  • Results were shown in results section.


  • Absorbance of LB is 0.7 at 600nm.
  • See table below for data point collected.
Hour Control (LB+cell) LB+Cell+clay/polymer film #1 LB+Cell+clay/polymer film #2 LB+Cell+clay/polymer film #3 LB+cell+silver incorporated clay/polymer film #1 LB+cell+silver incorporated clay/polymer film #2 LB+cell+silver incorporated clay/polymer film #3
  • Graph below shows the relationship between cell growth and time.

Personal tools