User:Moira M. Esson/Notebook/CHEM-571/2013/09/24

From OpenWetWare

(Difference between revisions)
Jump to: navigation, search
(General Protocol)
(General Protocol)
Line 23: Line 23:
##*Store prepared samples in the fridge
##*Store prepared samples in the fridge
##UV-vis sample preparation
##UV-vis sample preparation
-
###*Remove 0.75mL of sample(either pepsin or pepstatin) and add 0.75mL perchloric acid
+
##*Remove 0.75mL of sample(either pepsin or pepstatin) and add 0.75mL perchloric acid
#Repeat step 4 for two hours.
#Repeat step 4 for two hours.

Revision as of 15:34, 24 September 2013

Project name Main project page
Previous entry      Next entry

Objectives

  1. Observe the catalytic activity of pepsin and pepstatin.
  2. Collect four samples each of pepsin and pepstatin for SDS-PAGE to be run tomorrow.
  3. Run UV-vis to observe the effects of pepsin and pepstatin.


General Protocol

The following protocol was derived from this reference.

  1. Combine 5mL hemoglobin with 8.333μL of 1.2E-6M pepsin to make a solution with a final concentration of 2nM.
  2. Prepare a 5mL sample of hemoglobin with 83.3μL of 1.2mM pepstatin to make a solution with a final concentration of 20μM.
  3. Incubate these solutions at 37°C
  4. After 30 minutes, remove the two samples to prepare samples for SDS-PAGE and UV-vis
    1. SDS-PAGE sample preparation
      • Remove 10μL sample and dilute the sample to 1mL with 50mM Glycine-HCl buffer.
      • Take 10μL of the diluted sample and add 10μL of SDS-PAGE buffer.
      • Store prepared samples in the fridge
    2. UV-vis sample preparation
      • Remove 0.75mL of sample(either pepsin or pepstatin) and add 0.75mL perchloric acid
  5. Repeat step 4 for two hours.




Personal tools