User:Sarah Labianca/Notebook/Smyth Lab/2012/03/01
 Project name
|
<html><img src="/images/9/94/Report.png" border="0" /></html> Main project page <html><img src="/images/c/c3/Resultset_previous.png" border="0" /></html>Previous entry<html> </html>Next entry<html><img src="/images/5/5c/Resultset_next.png" border="0" /></html> |
Choosing an accelerometerI have decided to use the ADXL345 triple axis accelerometer. The reasons for this choice are as follows: -The measurement range is variable, we can choose ranges of ±2g, ±4g, ±8g and ±16g. This means that we aren't obligated to a certain measurement range, and can adjust this based on our needs. -The importance of the variable measurement ranges lies in the effect it has on resolution. The larger the g range, the smaller the resolution of our measurements. This is because the 1024 possible data points for measurements are divided up evenly over the g ranges. If we discover that the pendulum falls withing the ±4g range, we can use ±4g instead of ±8g or ±16g, effectively giving us a larger resolution, as compared to an accelerometer without variable ranges where we would be stuck using a certain, nonadjustable measurement range. This is even more useful because we do not know the force range of the pendulum. - To measure impacts, bandwidth (the amount of data that can reliably be output per second) needs to be in the hundreds of Hz. The ADXL345 has a variable hertz range of 6.25 Hz to 3200 Hz, allowing us to read impacts. -The ADXL345 should interface well with an Arduino, and comes mounted on a breakout board.
Side notesToday I found a piece of software called Fritzing that allows one to flesh out PCB board and breadboard designs virtually. A video of someone using Fritzing:
|
|
