Cell Count v Optical Density Curve Calibration
To produce a calibration curve to aid in the normalising of fluorescence values to allow proper characterisation of Promoters and RBSs for B.subitlis. This protocol must give results that are as accurate as possible over a considerable range of Optical Densities.
- P20, P200 and P1000 Gilsons
- 20ml of LB in a 250ml flask
- B.subtilis transformed with antibiotic selectable marker
- LB agar plates with anitbiotic
- Innoculate 20ml of LB broth with B.subtilis containing a selectable marker, we used B.subtilis transformed with spectinomycin. Incubate overnight at 37oC.
- Collect culture and measure the O.D.600.
- With the O.D.600 calculate how much of the overnight culture is required to give an O.D.600 of 0.5, 1, 1.5, 2, 2.5, 3 in 2ml using the following calculation:
- Vol of culture (ml)=(O.D.600 wanted / O.D.600 of Overnight culture) * 2ml
- Carry out the dilutions required using LB media to make the volumes upto 2ml.
- Remove 1ml of each dilution and then measure the O.D.600 and discard.
- Now carry out a series of 10 fold dilutions by removing 100ul of the dilution and adding into to 900ul of LB (this gives 10-1 dilution) carry this on until a suitable dilution is reached. We used the following dilutions:
- O.D600 of 0.5 = x10-6 and x10-7
- O.D600 of 1 = x10-6 and x10-7
- O.D600 of 1.5 = x10-6 and x10-7
- O.D600 of 2 = x10-6 and x10-7
- O.D600 of 2.5 = x10-6 and x10-7
- O.D600 of 3 = x10-7 and x10-8
- Plate 100ul of the appropriate dilutions onto an LB agar plate containing the antibiotic selectable marker.
- Grow the plates at 37°C overnight
- The following day count the number of colonies on the plates and multiply up by the dilution to obtain the colony forming units at each time point. Remember when plating the cells only 100ul of 1000ul was used to plate and so you need to multiply by a further 10.