# Physics307L F09:People/Phillips/eDiffraction

## Electron Diffraction Summary

#### Data & Results

After spending some time on the Internet and in Excel, we managed to procure some decent data:

SJK 15:51, 9 November 2008 (EST)
15:51, 9 November 2008 (EST)
I would say the extra digits on the uncertainties are excessive, making your results a bit tough to read. (0.139 ± 0.008) nm and (0.238 ± 0.031) nm would probably be what I would write. Others would argue for 0.24 ± 0.03 for the latter.

$d^{big}_{accepted} = 0.123 nm$

$d^{small}_{accepted} = 0.213 nm$

$d^{big}_{measured} = 0.139 \pm 0.00808 nm$

$d^{small}_{measured} = 0.238 \pm 0.0314 nm$

To calculate uncertainties, we used the formulaSJK 10:36, 11 November 2008 (EST)
10:36, 11 November 2008 (EST)
This is actually what you'd do if you were calculating the spacing based on a single value. However, what you're doing is: d = constant / slope (where slope is the LINEST result). In this case, you have an uncertainty in your slope from the linear regression. You then propagate error in slope to the d value, which is easy, it's just (δd/d) = (δslope/slope). See cell B66 in my modification to your Excel sheet. Image:Diffraction2 Michael SJK.xls

${\delta}d=\frac{\part d}{\part D}{\delta}D$

where d is the lattice spacing that we are finding and D is the extrapolated diameter that we measured.

For percent error, we used the formula

$% error=100\times\frac{|Accepted-Measured|}{Accepted}$

with our different measured and accepted values for the lattice spacing as a result of the big ring and of the small ring.

%errorbig = 13.0%

%errorsmall = 11.9%

The notebook entry for all of this is found here, and we have two Excel files that show all of our data and calculations: Diffraction1.xls and Diffraction2.xls.

#### Some Conclusions

In the end, I think we did pretty well. Our values were quite close to the accepted ones and we accounted for our uncertainty by examining the differences between values measured from the outer and inner parts of the rings. There are some other sources of error, such as the variance in the length, L, of our diffraction tube, but we ignored this, as suggested by the lab manual. One thing that I noticed was that the Least Squares error, from fitting a line to our data, was minimized when using the averages for our diameter values (i.e. taking the measurements for outer and inner parts of each ring, then averaging them), which is what we guessed and is why we used this method right from the start. There could possibly be something wrong with our uncertainty calculations, since we got quite small uncertainties in our final values, but we weren't quite sure what this could be from unless we just aren't taking everything into account.