Search results
From OpenWetWare
Jump to navigationJump to search
- chromosomes One step 'miniprep' method for the isolation of plasmid DNA Cleaning Glass Coverslips "Core Sample" PCR: Amplifying DNA from agarose gels "Broncho-alveolar...7 KB (4 words) - 18:37, 28 July 2006
- chromosomes One step 'miniprep' method for the isolation of plasmid DNA Cleaning Glass Coverslips "Core Sample" PCR: Amplifying DNA from agarose gels "Broncho-alveolar...7 KB (4 words) - 19:24, 21 August 2006
- close to zero degrees. Store the coverslips in a clean covered glass dish. For most consistent results, both coverslips and vesicle solution should be used...4 KB (628 words) - 16:33, 25 November 2010
- Larmann (1) Water Purification, Barnstead (1) Brett Boghigian (1) Cleaning Glass Coverslips (1) Speed Vac, Hybrid (1) SBB10Ntbk-MaziarBehtash (1) BISC 219/F10...95 KB (7,886 words) - 17:24, 3 October 2020
- Cleaning SiO2 surfaces Load coverslips into ceramic holder. Immerse in heated 20% 7x detergent for 5 minutes. Rinse coverslips thoroughly for 5 minutes...1 KB (201 words) - 21:42, 11 June 2010
- useful information. (3) Jennifer Lu (3) Katie Fifer/Design Docs (3) Cleaning Glass Coverslips (3) Steve Glynn (3) Computing/Python (3) Kathy's Notes (3) Tasha...179 KB (13,968 words) - 17:24, 3 October 2020
- method for the isolation of plasmid DNA (1) Reference tables (1) Cleaning Glass Coverslips (1) Brown (1) Brown/Characterizations (1) Sortostat/Experiments/Brian...195 KB (15,775 words) - 04:50, 25 August 2010
- provided in the clean-up area near the sink. 4. Glass slides or non contaminated and empty disposable glass tubes can be discarded in the glass disposal box...24 KB (4,017 words) - 15:45, 20 September 2013
- the surface of the coverslip, use microscope lens cleaning paper and a "light touch" so not to break it into pieces. Place the coverslip over the counting...5 KB (685 words) - 20:36, 14 September 2008
- BISC209/S12: Lab2 (section CLEAN UP)fritted glass filter support with rubber stopper) Carefully place a 0.2μM glass fiber filter (Isopore membrane GTTP02500) onto the fritted glass filter...35 KB (5,453 words) - 17:07, 7 February 2012
- BISC209/S13: Lab2 (section CLEAN UP)fritted glass filter support with rubber stopper). Carefully place a 0.2μM glass fiber filter (Isopore membrane GTTP02500) onto the fritted glass filter...35 KB (5,622 words) - 20:13, 13 February 2013
- the glass, and 2) coverslip is uniformly amino‐functionalized. 1. Load coverslips into rack (available from flowcell supplier) 2. Immerse coverslips in...23 KB (4,075 words) - 10:22, 6 February 2008
- oxygen tank. Remove the chip and glass coverslip, and put the PDMS channel-side down on the glass (onto the side of the glass that was facing up). You should...8 KB (1,335 words) - 20:15, 14 July 2016
- seconds. Pipet 1–2 (5ul) drops of permanent mounting medium, cover with a glass coverslip and observe by light microscopy. Chromogen only; no primary or secondary...18 KB (2,571 words) - 22:01, 27 February 2023
- BISC209/S11: Lab3 (section CLEAN UP)fritted glass filter support with rubber stopper) Carefully place a 0.2μM glass fiber filter (Isopore membrane GTTP02500) onto the fritted glass filter...62 KB (9,947 words) - 12:18, 7 June 2011
- inches of clearance between the glass slide and the lens. Using the stage adjustment knobs, position the edge of the coverslip in the center of the illuminated...18 KB (2,912 words) - 15:50, 31 January 2013
- Once dried (~5min) remove one of the coverslips and the gasket. Remove any excess agar from the sides of the glass slide until a nice circle is left (usually...3 KB (330 words) - 03:17, 2 July 2013
- inches of clearance between the glass slide and the lens. Using the stage adjustment knobs, position the edge of the coverslip in the center of the illuminated...17 KB (2,819 words) - 16:05, 16 September 2013
- 10mL using the gradations on the pipettes. They may be made of glass or plastic. Glass pipettes are washed and reused, while plastic pipettes are disposable...33 KB (5,516 words) - 16:30, 10 September 2010
- between well dividers is sufficient to prevent bleeding of drops on the glass there is the potential for bleeding which is not good if you try to assay...6 KB (1,060 words) - 18:28, 24 November 2020
